This device also has a 3MP rear camera, a GPS, bluetooth and a memory card slot for memory expansion.ģ.2 inches, 31.7 cm 2 (~50. It has a removable 1000 mAHh battery that can stay on standby up to 250hours and has a talk time of up to 3hours.

It has a 3.2' capacitive touchscreen with 240x320 pixels in resolution. It has a rugged body and is made of 67% recyclable materials. ArmorSuit MilitaryShield Pantech Renue Screen. ArmorSuit MilitaryShield Pantech Renue Screen White Carbon Fiber Skin.

For Pantech Renue P6030 Hard Faceplate Phone Accessory Cover Case. Pantech Renue P6030 2X Pack Mirror Screen Protector LCD Phone Cover ATamp T. Now you basically reverse the process to put the phone back together with the new screen.Ī: Be mindful of which way you reconnect the keyboard slider to the screen.The Pantech Renue P6030 is a messaging phone that has a slide-out QWERTY keyboard. Hard Faceplate Cover Phone Case for Pantech Renue P6030. Now you should be looking at the back of the rectangular touch screen in the glass caseġ4: Carfully unplug the littie black square circuit connector from the circuit board which controls the phone's send/end buttons (look at your new phone screent to see where that connector is located)ġ5: Carefully remove the touch screen, speaker & wires, & send/end button board (they are all connected together by a ribbon cable) The speaker should just pry outġ6: Set the touch screen components down (screen side up)ġ7: Remove the send/end buttons from the old screen & install them in the new screen Note:Be carefull not to break the small ribbon cable next to the buttonsĩ: Unplug the larger ribbon cable from the circuit boardġ0: Lay the phone out like an open clam shellġ1: Remove the 8 silver screws that connect the keyboard to the screenġ2: Now that the screen is separated from the phone remove 6 screen screws (3 of the screws are covered by stickers)ġ3: Carefully push/pry to separate the screen back from the glass cover 3: Pop off the dimpled cover that surrounds the camera lensĤ: Remove 6 screws around the edge of the black phone backĥ: Unscrew the one additional screw in the center of the black coverħ: Note where the volume & camera buttons are & how they are installed before proceedingĨ: Lift up the loose side of the phone circuit board (the other side is connected by 2 ribbon cables

Pantech p6030 phone